02-23-2024 09:30 AM
Have an autonomous ap im configuring for use. When i enter the password in ASCII format it tells me I can't use a ? character. Is there any way around this? This is my software version,
Cisco IOS Software, C1140 Software (C1140-K9W7-M), Version 15.3(3)JD17, RELEASE SOFTWARE (fc2).
Thanks.
Solved! Go to Solution.
03-18-2024 09:54 AM
So it would help if i payed attention. I was using the easy setup GUI when creating the SSID. In the text box it said to enter a password in "HEXADECIMAL" format. That's where the ? isn't allowed. The ? is allowed in the ascii format in the SSID Manager.
02-23-2024 09:45 AM
Try pressing Ctrl+V and then the question-mark.
02-23-2024 10:11 AM - edited 02-24-2024 05:31 AM
No ? is not allowed in PSK on Cisco autonomous IOS APs, even on WLC.
02-23-2024 11:47 AM - edited 02-23-2024 11:49 AM
I was under the impression that I had used "?" before, but I was not sure. So, I tested it on my 9800-CL, and it works with question marks. Perhaps that changed sometime in the past?
wlan TEMP-TEST 99 TEMP-TEST
security wpa psk set-key ascii 0 123??678
no security wpa akm dot1x
security wpa akm psk
security pmf optional
no shutdown
03-18-2024 09:54 AM
So it would help if i payed attention. I was using the easy setup GUI when creating the SSID. In the text box it said to enter a password in "HEXADECIMAL" format. That's where the ? isn't allowed. The ? is allowed in the ascii format in the SSID Manager.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide