Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've successfully configured extension mobility which i will shorten to em. The purpose of this feature for my organization is so that my office coordinators can take their extensions with them when they go to different reception areas. The problem i...
I have my data center router and 10 remote routers that all connect back to the data center in a hub and spoke topology. I use an ISP to connect the remote sites to the data center using MPLS, they say it's a theoretical layer 2 connection. One of my...
I have a dhcp server that handles ip addressing for our sites. I made a 10.1.72.0/21 subnet. I want this subnet to house all the ips for devices on vlan 72. Locally I was able to achieve that. But I can't figure out how to achieve this from a differe...
I have an 8821 and it works great. The thing i was curious about, is the phone suppose to stay connected to a call while you leave the range of one AP and get in range of another? Is there something i have to do to have it work? Currently it loses th...
When trying to change someone to co-host in outlook with the webex add in this error code appears,(00_100313,b0c6bc55028c4816ae5ba3e231c78d75)We're having a problem communicating with the Cisco Webex Meetings service. Try again later.I suspect this s...
Here is the scenario. I have 8 reception areas. all have their own hunt group. I have a user that works at a different reception area each day. If i were to apply your configuration then this one user would need to have 8 hunt groups tied to their em...
Thank you for this reply. This will work, but it wouldn't be practical. By this design my office coordinators would have 8 hunt groups attached to the DN and would receive too many calls when they log in with em
Thank you everyone. The issue is resolved. It was the fault of my isp. They still haven't pinpointed why a connection can't be made. What they did was swap my wan link port to another open port on their router. My remote router immediately came onlin...
Btw the config for interface GigabitEthernet0/0/1.40 is blank. I just wanted to illustrate that i was intending on using that sub interface for the bridging.
