09-20-2017 02:11 AM - edited 07-05-2021 07:40 AM
Hi
I would like to make an Lightweight AP Configuration Templates for shutting down my AP at regular basis in Prime 3 every night between 22.00 – 06.00
How thus I do it in Prime 3
regards
Johan
Solved! Go to Solution.
09-20-2017 03:02 AM
Depends on what you mean by shutdown. If it's driven by PoE switches you could schedule jobs that shutdown the ports. If you just want to stop them from sending out wireless signals you could create an lightweight AP template that shuts down the radio.
Make one template for shutting them down and another to power them up.
Switch template would be most eaily done by CLI template, haven't tried it myself.
Shutting the radio down would be under the following
configuration -> templates -> lightweight access points, create a new template, select the 802.11a/n/ac, check the "admin status" box and make sure the "enable" box isn't marked. Do the same for the 802.11b/g/n tab, select which access point to do it on and the set the schedule.
Hope it helps.
//Peter
09-20-2017 03:02 AM
Depends on what you mean by shutdown. If it's driven by PoE switches you could schedule jobs that shutdown the ports. If you just want to stop them from sending out wireless signals you could create an lightweight AP template that shuts down the radio.
Make one template for shutting them down and another to power them up.
Switch template would be most eaily done by CLI template, haven't tried it myself.
Shutting the radio down would be under the following
configuration -> templates -> lightweight access points, create a new template, select the 802.11a/n/ac, check the "admin status" box and make sure the "enable" box isn't marked. Do the same for the 802.11b/g/n tab, select which access point to do it on and the set the schedule.
Hope it helps.
//Peter
09-20-2017 04:47 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide