Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

Resolved! Wireless

I have an AP that failed. I need to replace it. However I cannot find that AP in the any of my the controllers. I see the AP list on the controllers' web GUI. However the MAC for this AP is not on the list. How do I identify what the previous configu...

androsian by • Frequent Visitor
  • 2589 Views
  • 7 replies
  • 0 Helpful votes

I've tried everything but I can get the CAP to keep a static ip address.  I've entered it the WLC GUI from the panel shown below, bottom right, from the WLC CLI [(Cisco Controller) >config ap static-IP enable AP1 192.168.170.100 255.255.255.0 192.168...

Wireless_CAP_issue.png

Hi,we have a IR829 with an integrated AP803. The router works fine but when we reverse telnet in the router to gain access to the console of the AP, we see that the AP803 is stuck in ROMMON.When we do boot, the AP tries to boot its firmware but after...

Hello All, I have 2 5508 WLC and 2700 Aircap AP's and currently we are using radius server for authenticate wireless users.but now we are moving toward to Azure so how can we authenticate users through Azure AD. Ps. We tell me if its posible throuhg ...

ISE ver. 2.0.0.306iPhone IOS 12.4App  PBIS    https://www.pbisrewards.com/   application not running correctly/sporadically running after several restarts.  pbisrewards.com and all subdomains (*.pbisrewards.com)motivatingsystems.com and all subdomain...

bskossmann by • Community Member
  • 1071 Views
  • 1 replies
  • 0 Helpful votes

Hello All Communitty, I have a Question Regarding WLC 3504.  I just bought a basic unit WAP371 and WLC 3504 just for testing and i cannot see  AP joins the WLC. Does this basic Unit (WAP371) supported by  WLC 3504 ?  if not than which Access Points m...

HiAm trying to set up some APs in Flexconnect mode that connect to a WLC runnng 8.3.143.0 that will advertise an 802.1x profile.  The RADIUS server (ISE) matches the user against AD and then returns different VLAN values in the Authorisation Profiles...

I work for a public Library and We have a handful of mostly MR42s with a couple of MR34s and an MR18 in the mix. We have a splash page that I configured to require clicking through and accepting terms once a day. Staff are complaining that they're be...

LibraryGirl by • Community Member
  • 10949 Views
  • 10 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card