Single WLAN for Multiple Locations

[psnead]

I would like to implement a single WLAN 4402 in a primary site and have it also control about 5 Lightweight APs in 2 remote locations. The WAN between the sites is very robust. I need to know if there are any problems with this configuration? Will I be able to configure the 4402 to handle 3 DHCP zones? Are there any other considerations with this config?

Thank you for you help.

[#2]

Cisco WCS provides an intuitive and visually rich centralized management interface for the Cisco Wireless Location Appliance. One or multiple Cisco Wireless Location Appliances can be managed by the Cisco WCS. Cisco WLAN Controllers must be associated with the Cisco Wireless Location Appliances to collect location data. RF predictions and heatmaps can be generated by adding network maps and access points. The location of thousands of devices is graphically displayed on floor plans within the Cisco WCS. The Cisco WCS periodically polls the Cisco Wireless Location Appliance for its status and for changes to maintain synchronized control data such as network maps. The Cisco WCS also is used for access control setup for the location appliance; definition of content and frequency of polls; and configuration of archive parameters as well as for logging and viewing server events and severity levels.

http://www.cisco.com/en/US/products/ps6386/products_qanda_item0900aecd8029371a.shtml

http://www.cisco.com/en/US/products/ps6386/products_data_sheet0900aecd80293728.html