tacacs+ on WLC CISCO

[Nadia Bbz]

Dear Team ;

i have configured the device administration of cisco WLC using tacacs+ on WLC using Tacacs+

all work fine but when i connect via ssh i can't see in ise the command hits per  user ( Command From Device  is white ) as show in picture below, On the other hand i can see the hits command in switch

thanks in advance for help

[MHM Cisco World]

https://www.networkworld.com/article/2982952/device-administration-with-cisco-wlc.html

check this link it answer for your question.

[Scott Fella]

EDIT:

Are you sure you are hitting a policy when you try to access using ssh?  You can look at the live logs detail and look at the device port, because http and ssh would show different.

[Nadia Bbz]

Dear @Scott Fella  ;

the configuration that i was done is in attached