cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
717
Views
0
Helpful
3
Replies

tacacs+ on WLC CISCO

Nadia Bbz
Level 1
Level 1

Dear Team ;

 

i have configured the device administration of cisco WLC using tacacs+ on WLC using Tacacs+

all work fine but when i connect via ssh i can't see in ise the command hits per  user ( Command From Device  is white ) as show in picture below, On the other hand i can see the hits command in switch

 

log.JPG

 

thanks in advance for help

 

 

3 Replies 3

Scott Fella
Hall of Fame
Hall of Fame


EDIT:

Are you sure you are hitting a policy when you try to access using ssh?  You can look at the live logs detail and look at the device port, because http and ssh would show different.


-Scott
*** Please rate helpful posts ***

Dear @Scott Fella  ;

 

the configuration that i was done is in attached

Review Cisco Networking for a $25 gift card