Third Party POE Injector for the Cisco AP4800

[kidimbwi]

looking at the getting started guide for the AP4800, i can see that one can only have full functionality when using 803.bt or uPoE. can i be able to use this injector from Zyxel: https://www.zyxel.com/us/en-us/products/switch/5g-poe-injector-poe12-60w/overview and have full functionality ?

Thank you.

[Leo Laohoo]

By default, a 4800 uses about 33.0wac.  

Cisco's power injector are made by a company called PhiHong.  Look for an injector that can do 60wac.

[kidimbwi]

interesting, Thank you for pointing me to Phihong. so is it safe to say that any injector that provides 60wac can be used to power the AP4800 adequately ?

[balaji.bandi · Accepted solution]

yes, it should work as long as it has the output mentioned to boot AP.

I have used non-branded to power up the AP, they work as expected as long as the meet the requirement.

[Leo Laohoo]

Yes, PhiHong injectors are fine.

[eglinsky2012]

I’ve had good luck with the TRENDnet TPE-117GI.

https://www.trendnet.com/products/poe-injector/gigabit-UPoE-injector-TPE-117GI-v2

[kidimbwi]

Thank you everyone. you've erased all my doubts and, along the way, given me some great recommendations. your contributions are much appreciated.