Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

Hi all, new here, am deploying a wireless network using the Cisco WLC series 9800 and APs, APs have successfully joined the controller but the SSIDs i created are not been broadcasted from the APs. Have anyone face this challenge before kindly advise...

richprime890 by Frequent Visitor
  • 1398 Views
  • 5 replies
  • 0 Helpful votes

Hey all-TL:DR is mobility group between foreign WLC (AirOS) and anchor WLC (9800) appears to have CONTROL path UP and DATA path down.Foreign: 5520 on 8.10.185.0 and 8540 on 8.8.125.0Anchor: 9800 on 17.9.4aBackground: Our enviroment has 10+ foreign WL...

KyleA by Visitor
  • 3486 Views
  • 4 replies
  • 0 Helpful votes

Hello everyone,I have rather specific question about syslog on 9130 aps. I would like to activate syslog on the access points. We have a Redhat Rsyslog, and my colleague mentioned he's having some difficulties, if the syslog string doesn't include th...

herophil322 by Frequent Visitor
  • 1142 Views
  • 2 replies
  • 0 Helpful votes

Hello Everyone! I had a question related to licensing for the Umbrella integration part with MR. The document says the "Manual Integration (API integration) will require an Umbrella license.I just wanted to confirm that if the Automatic Umbrella inte...

Hello all , I just purchased a handful of 3702i aironet AP’s and am trying to get ahold of software , but I am trying to use these at my house , I am teaching myself and building a home lab , I do not have the means to obtain a service account , as I...

acekinghatin by Community Member
  • 1040 Views
  • 2 replies
  • 0 Helpful votes

Resolved! Cisco AP stby 9115

I would like to operate 2 products of cisco ap 9115. You set the virtual controller IP for the two APs to XXX.XXX.XXX.232. IP was set to 233 and 234 respectively as an Access Point. If you boot after setting it up like this, one AP will boot to stand...

heyjunsun by Level 3
  • 2678 Views
  • 8 replies
  • 0 Helpful votes

ProblemClient is unable to complete AUTH sequence with SSID A of MR33 after having been connected to SSID B of same MR33 and not cleanly disconnecting from SSID B (client powered off while connected to SSID B). The AP does not respond to the AUTH req...

supurloop by Community Member
  • 1583 Views
  • 3 replies
  • 0 Helpful votes

Resolved! License Expiration

Hi, I have this warning in my Dashboard. Will my network stop working on that day(Jan 17) or do I still have 30 days grace periodo after January 17, 2024 to add my license? We have already purchased the license but have not yet received the serial nu...

image.png

So after 5 years or so of our full stack Meraki implementation complaints in a particular area of our building are ever more increasing. We have users who are sat working happily on 5 bars of signal strength connected to their local AP and then for n...

image.png
GaranT by Community Member
  • 17994 Views
  • 13 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card