cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1208
Views
0
Helpful
8
Replies

unable to access WLC GUI

shawntls82
Level 1
Level 1

Hi ,

We have 2 unit of WiSM2 deployed, one at Core switch1 and the other unit at Core switch2, these 2 units are belong to same management subnet for example 10.1.1.x 255.255.254.0

we are able to ping both units but only able to get into the GUI of the first unit, let's say 10.1.1.1 but not able to get into GUI for 10.1.1.2

we have checked the firewall and it's not blocking.

any idea on how to access the 2nd unit GUI or fix the issue?

Thanks.

8 Replies 8

George Stefanick
VIP Alumni
VIP Alumni

A few things ..

1. If your second controller is in HA mode you wont be able to see it .

2. Were you trying to access the WLC over wireless? If managment over wireless is disbaled you wont be able to access it ..

try to log into the wlc from the wired

__________________________________________________________________________________________
"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin
__________________________________________________________________________________________
‎"I'm in a serious relationship with my Wi-Fi. You could say we have a connection."

"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin
___________________________________________________________

shawntls82
Level 1
Level 1

Hi George,

They are running Active - Active, we have already enable management via wireless.

It's the same result even if we try on wired.

Sent from Cisco Technical Support iPhone App

No ACLs or anythign blocking it ? Did you try rebooting the box?

__________________________________________________________________________________________
"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin
__________________________________________________________________________________________
‎"I'm in a serious relationship with my Wi-Fi. You could say we have a connection."

"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin
___________________________________________________________

shawntls82
Level 1
Level 1

There wasn't any ACL blocking, we haven't try rebooting it though as this is in production, need to plan down time

Sent from Cisco Technical Support iPhone App

Scott Fella
Hall of Fame
Hall of Fame

There have been issues in the past regarding this and also ssh/telnet. Varies depending on WLC model and version. If you don't have anything blocking like George mentioned, then either search the bug toolkit or open a TAC case. The fix for this was a reboot until a firmware fixed the particular issue.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***

Viten Patel
Cisco Employee
Cisco Employee

What is the wlc code?

Sent from Cisco Technical Support iPhone App

shawntls82
Level 1
Level 1

WLC code is 7.3.101.0

Sent from Cisco Technical Support iPhone App

mmangat
Level 1
Level 1

Hello,

There is a good document on this forum that you can check to get the resolution for your issue:

https://supportforums.cisco.com/docs/DOC-4779

Review Cisco Networking for a $25 gift card