Unable to ping Cisco 3802i WLC Controller

[sheikhrazib2766]

I've been working on a Cisco 3802i WLC. I am unable to ping the Management IP address of WLC. 

- I've followed step-by-step instructions from Cisco, how to configure 3802i WLC. 

- Configured with proper IP address, subnet mask and gateway IP address. 

- I've tried different switch/routers connected with this WLC, still not pingable. 

- Used with different vlan config (trunk/acess/native vlan) on the switch...but the IP is not pingable

- WLC's mac address appears on correct vlan on the switch, but not pingable.

- I configured another AP and put that on same vlan and the AP is pingable from my laptop.

- APs are not joining the WLC, my assumption is if the WLC is not pingable then the joining process will fail.

- Also reconfigured the WLC several time, nothing worked.

I've been stressing for last few days, going thru all the resources that I can find and was not able to resolve this issue. 

Any help would be Highly appreciated. 

[Rasika Nayanajith]

If you put a PC on that AP management vlan, would you be able to  ping WLC mgt from that PC ?

HTH

Rasika

[sheikhrazib2766]

Tried that. Ping didn't work.

I can't even ping the WLC from switch where it WLC is connected to. 

In Switch show cdp nei doesn't show WLC's IP address either.

[Rasika Nayanajith]

from your WLC (by the way what model is it? ) , pls share "show interface detailed management" output and "show run interface Gig x/x" on switch where this WLC connect to.

HTH

Rasika

[Nelson Kim]

I would want to see the configuration from the 3802i you're using as a WLC.

[sheikhrazib2766]

Hello Nelson,

Running-Config is attached. Thanks

[patoberli]

Please post this:
from your WLC (by the way what model is it? ) , pls share "show interface detailed management" output and "show run interface Gig x/x" on switch where this WLC connect to.