VLAN assignement and Flexconnect local switching

[nideville]

Hi,

I have a WLC 2504 running in 8.2.151.0 with 1852 APs

I have configured a SSID with 801.X through a NPS.

The NPS assign different VLAN depending on some criteria (3 different VLAN)

This works fine when I use central switching.

I now want to have local switching for those 3 VLAN.

But when I configure VLAN Mapping, I can only associate 1 VLAN to an SSID

I've tried several things but I can't figure out how to do this (and even if this is possible).

Any ideas ?

Best regards,

Nicolas

[Rasika Nayanajith · Accepted solution]

Here is the feature matrix for FlexConnect. It is supported

http://www.cisco.com/c/en/us/support/docs/wireless/5500-series-wireless-controllers/112042-technote-wlc-00.html

Below link may be also useful

https://www.youtube.com/watch?v=l8b8SCdphJo

HTH

Rasika

*** Pls rate all useful responses ***

[nideville]

Hi,

My mistake was that I had forget to create AAA VLAN-ACL mapping in flexconnect Group.

Without this, the subinterface for each vlan was not created on AP.

Thanks for your help !