07-26-2017 07:11 AM - edited 07-05-2021 07:25 AM
Hi,
I have a WLC 2504 running in 8.2.151.0 with 1852 APs
I have configured a SSID with 801.X through a NPS.
The NPS assign different VLAN depending on some criteria (3 different VLAN)
This works fine when I use central switching.
I now want to have local switching for those 3 VLAN.
But when I configure VLAN Mapping, I can only associate 1 VLAN to an SSID
I've tried several things but I can't figure out how to do this (and even if this is possible).
Any ideas ?
Best regards,
Nicolas
Solved! Go to Solution.
07-26-2017 07:11 PM
Here is the feature matrix for FlexConnect. It is supported
Below link may be also useful
https://www.youtube.com/watch?v=l8b8SCdphJo
HTH
Rasika
*** Pls rate all useful responses ***
07-26-2017 07:11 PM
Here is the feature matrix for FlexConnect. It is supported
Below link may be also useful
https://www.youtube.com/watch?v=l8b8SCdphJo
HTH
Rasika
*** Pls rate all useful responses ***
07-27-2017 12:39 AM
Hi,
My mistake was that I had forget to create AAA VLAN-ACL mapping in flexconnect Group.
Without this, the subinterface for each vlan was not created on AP.
Thanks for your help !
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide