VLAN Select - Interface dirty - Index based on Mac Address

[noc]

Hello Experts,

we are testing the VLAN Select Feature with a 5508 controller, version 7.0.230 and two /23 DHCP Scopes on an external dhcp server. Our cookbook is following document:

http://www.cisco.com/en/US/products/ps10315/products_tech_note09186a0080bb4900.shtml

Now i have a few questions

1 - Is there any chance to see the calculated index based on the Mac Address to which the interface is assigned to the client. I try "debug client MAC-ADDRESS" and "debug dhcp", Maybe i overlook it, but i can't find any information to that index.

2 - Is there a cli command to delete the index? It would be great for testing purposes and troubleshooting.

3 - Is there a cli command to look, if the interface is "dirty"?

4 - Our DHCP Server has a lease time of 5 Minutes. Is it possible to set the interface dirty time to a value less than 30 minutes?

Best Regards,

Michael

[aaronleech]

I know this is an old post - but I ran across it trying to find an answer to the same questions.

Did you ever find any answers?  I did find an answer to question 3, show interface group detailed.

But I haven't found a way to delete the indexes short of rebooting all the controllers, and apparently you would have to reboot them all at the same time.

[Saravanan Lakshmanan]

these requests are geniune and should have been available, enhancement request filed asking these info long ago. hopefully expecting fix in future release. you can also touchbase with SE/AM and raise PER for the same.

as for as i know this feature initially had complaints but it got stabilised on wlc code 7.4MR and higher.