Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 4, 2025 through Friday, August 15, 2025. Our colleagues Saikat Nandy and Parithosh Vema will be waiting to assist you ...
Forum Posts
Resolved! cisco prime infrastructure L2 mapping
hi all, I need the feature plan for cisco PI 2.1 to know if I can draw the L2 topology or not ? thanks in advance
Resolved! Security for Internal WLAN
I'm trying to figure out the best way to set up authentication on my WLAN for my internal users. I want to use certificates but I'm not exactly sure what layer 2, layer 3 and AAA settings I need to configure for certificates. If I do certificate auth...
Hi.. I have implemented & configured WLC for EAP-FAST certificate authentication.I have CA on windows 2008 server. When i request to generate user certificate on to CA server from IE9 i get option page "Create and submit a request to this CA." but w...
Does anyone have experience with encrypting CAPWAP tunnels on between your AP's and WLC's? According to:http://www.cisco.com/c/en/us/td/docs/wireless/controller/6-0/configuration/guide/Controller60CG/c60lwap.html#wp1508163"Encryption limits throughp...
Hi, I have a building on campus which have a microphones system that use channel 1 for operation. Can I configure the access points there to use DCA on a different scope than the rest of my campus? I have two 5760 controllers running the latest versi...
Hi, I have lately created a new PEAP WLAN but it is not relected the option on Lobby Ambassador Guest Management.Any idea on this?
Strange issue, not sure if anybody has seen this before.A new pair of 3850's in a stack.IOS XE 3.3.3SE, IP Services.AP's on switch 1and2 register ok.AP's on switch 1 advertise WLANs and service clients.AP's on switch 2 advertise WLANs but do not serv...
Resolved! BYOD Projecct Plan Preparation
Hi All, Hope all are doing well. I Need one help from your side i am planning to start Cisco BYOD solution Project (Switching,Wireless,Security and Management Solution ) Please help me if any one have Project Implementation plan for BYOD RegardsMuh...
Resolved! AIR-WLC526-K9 usb function?
Hi, i have an AIR-WLC526-K9 and notiched that is holds 2 usb ports.but my experience with an PIX515E and PIX506E, also having 1 usb port, is that these ports are just for show. because there is no functionality/use for them on the software side.or no...
Hello , kindly i have 2x WISM2 installed with HA ver 7.6.120 , the strange thing that i can not access the WISMs through 6500 CLI via session command .it gives me connection refused by remote system .but before HA i could .the service port IPs are ...
Hello All, I have implemented a stack ( one active and one standby controller) of 5760 controllers at a customer site. There are several floors in the building and I assigned an AP group and VLAN per floor. I am broadcasting single SSID in all the f...
hi all, I have cisco AP 1121 autonomous connected to my core switch, I can see it on the cdp neighbors with its IP and they are running but i cannot ping them or telnet them? the port that connected on the AP is trunk.what may be the problem ?? pleas...
Resolved! Wifi Traffic flow from PC to DHCP server
Hi Everyone, Below is Wireless setup. WAP-------------------Switch -----------------WLC As per above WAP has single connection to switch and WLC has 2 connections to switch.WLC has default gateway which is ASA.Switch also has default gateway which ...
Resolved! WLC and ACL traffic flow
Hi Everyone,For WLC i need to config some ACL to strict the traffic flow.Do i need to config ACL in both directions ?Like in ASA return traffic is allowed as it is stateful does i need ACL for return traffic from outside to inside also? RegardsMAhes...
Resolved! Ip helper address and WLC
Hi Everyone, WLC has IP 10.10.10.5AP has IP 10.10.10.6AP is connected to switch which has say vlan 10 IP 192.168.50.2 AP manager interface has IP 192.168.50.1 USer is getting IP from ASA which has pool in subnet 192.168.50.xDo i need to config ip ...
