VLAN Select (Interface groups) and Outdoor AP 1552

[Johannes Luther]

Hi board,

I'm just reading the 7.2 release configuration guide and found this:

http://www.cisco.com/en/US/docs/wireless/controller/7.2/configuration/guide/cg_ports_interfaces.html#wp1384874

Chapter VLAN Select - "Guidelines and Limitations"

The following lightweight access points are  supported: Cisco Aironet 1120, 1230, 1130, 1040, 1140, 1240, 1250, 1260,  3500, 1522/1524 Access Points, and 800 Series access points

Does anybody know if the 1552 outdoor AP (local mode) is supported with VLAN select? It's not listed in the config guide (as well as the 3600). I surely hope so 🙂

[Scott Fella · Accepted solution]

As long as the 1552 is in local mode, it has the same features as the other AP's listed and vlan select is one of them. If you change the role to bridge, then no.

Sent from Cisco Technical Support iPhone App

[Johannes Luther]

Thanks a lot! By the way - the answer was pretty fast (2 minutes after posting the question).

--> Maximum respect 🙂

[Scott Fella]

Haha... This is what great about this forum.

Sent from Cisco Technical Support iPhone App

[Saravanan Lakshmanan]

changing the role to bridge may still have the interfacegroup working on G radio for wireless clients and A radio if client access for backhaul is enabled.