
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-25-2017 01:54 PM - edited 07-05-2021 06:44 AM
Hi, i have a vWLC 8.2.130.0 with 1x 3602E AP and 1x 1142I AP in a bridge setup.
The 3602 is configured as flex + bridge and as a root AP.
The 1142 is configured as flex + bridge and as mesh a mesh AP.
im trunking 2 vlans across the bridge, vlans is in transparent mode.
everything seems ok and it works fine, but after 10-15 min the 1142 AP disconnects.
Its not restarting, its only dropping the connection for some minutes, and have a interface reset.
here is the log from the controller:
I have done a restart of both AP's and the controller, but its still same behaviour.
anyone have some tips?
Thanks,
Number of Traps since last reset | 19 |
---|---|
Number of Traps since log last viewed | 19 |
|
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Solved! Go to Solution.
- Labels:
-
Wireless LAN Controller
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-25-2017 02:43 PM
Why not just set the to bridge mode? Also if you are using the 5ghz as the backhaul, set the channel to 165 or a non DFS channel. I would also set the power to max to see if the link will stay up. Also as best practice, configure a bridge group name for you mesh AP's.
-Scott
*** Please rate helpful posts ***
*** Please rate helpful posts ***
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-25-2017 02:43 PM
Why not just set the to bridge mode? Also if you are using the 5ghz as the backhaul, set the channel to 165 or a non DFS channel. I would also set the power to max to see if the link will stay up. Also as best practice, configure a bridge group name for you mesh AP's.
-Scott
*** Please rate helpful posts ***
*** Please rate helpful posts ***

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-27-2017 12:30 PM
It worked when i created a group and added them there!
I need to use flex + bridge because im using a virtual WLC
