Warning In SNMPV2 No Defaults Presents. Please use command: config s n

[danwitney77]

I successfully converted my 3802i ap from lightweight to ME But i cant access it via web interface and it has these warnings below when i put the user and password

User: EBENEZER
Password:*********
Warning: Missing TFTP/CCO params, Please Configure the Image Download Params

Welcome to the Cisco Mobility Express command line interface.
Only commands which are listed in the command reference guide for this release are supported.
http://www. cisco . com/c/ e n /us/support/ wireless/   mobility-express/ products-command-reference 

Warning :In SNMPV2 No Defaults Presents.
Please use command: config S N M P community create <name>

Warning :In SNMPV3 No Defaults Presents.
Please use command: config  S N M Pv3user create <username>

(Cisco Controller) >

the PROBLEM is i don't know how to use the S N M P and i don't know it has come out like this, any help rendered will be appreciated, thanks

[marce1000]

  - @danwitney77   Ignore this  message because it is not important : Warning: Missing TFTP/CCO params, Please Configure the Image Download Params

                            To configure snmp properly have a look at : https://mrncciew.com/2013/02/14/configuring-snmp-on-wlc/

                            To enable the web interface use the CLI command config network webmode enable

  M.

[balaji.bandi]

what code you using for ME:

check basic guide lines how you can access to GUI :

https://www.cisco.com/c/en/us/td/docs/wireless/access_point/mob_exp/1/user_guide/b_ME_User_Guide/getg_start.html#task_7588F4C009744AEFBB9EB754A713E390

[MHM Cisco World]

Are you sure you success to convert?

It seem to me the AP auto download ME image which is missing

Share please 

Show version 

MHM