Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
675
Views
3
Helpful
2
Replies

WEB Authentication Certificate on WLC4400 - Guest Access

BeechLiam
Level 1
Level 1

‎01-08-2009 07:11 AM - edited ‎07-03-2021 04:57 PM

I need to know if there is a debug command to trouble shoot Web Authentication Certificate Issue for Guest Access. I'm currently troubleshooting an issue to verify if our Anchor controller is passing redirects to our web Server. Any advise would be appreciated.

This is on a WLC4404 Controller

Labels:
0 Helpful
2 Replies 2

sschmidt
Cisco Employee
Cisco Employee

‎01-08-2009 08:31 AM

Is the redirect url configured with a name or IP address? If it is a name make sure there are no issues getting DNS resolution of the name.

The best troubleshooting method I can recommend is using a sniffer to capture the traffic at the anchor controller towards the webserver to see if the traffic passes to the webserver.

BeechLiam
Level 1
Level 1
In response to sschmidt

‎02-25-2009 01:14 AM

No issues with the DNS resolution. it may be an issue with the SSL certificate. root CA. I'm using code 3.2.171.6 as we need to use this for ipsec vpn module. After a quick reboot , everything goes back to normal. thanks for the advise

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card