Wireless

Hi all,I am trying to set up radius authentication for the management users of WCS. I am using freeradius.I created a user and set included the necessary group tasks in the reply using Cisco-AVPair. I can see in the debug on the radius server that th...

hiwhen i try to set SSID in my access piont with CLI.  with commandAP(config)#interface dot11Radio 0 it is a invalid command.??? i tried  several times. what's wrong here????/

Simple question - does removing the checkmark next to the "Admin Status" field disable the "A" radio completely?  I'm trying to prevent power alarms b/c we don't have sufficient POE to power up both A and B/G radios.TIA,Amir

I have a AP1220A I'm looking to configure it so that it blindly connects to any unsecure network.And then I will be able to use the CAT5 to provide my router with internet connectivity.Is this possible?

Hello everyone, I've been trying to track down a very stubborn problem that I've been having at 2sites now; the client computers show repeated syslog entries ofEvent 4201 - The system detected that the [XXX adapter name] was connected to the network,...

I have a couple of Aironet 1100 series APs that should be connecting with a Cisco WLC 4400. Started with one that was seen but not set to the correct radio setting but the WC didn't have a place to reconfigure that setting which I could see. So using...

Hi to all,I've reading a bit about this and i'm a litle confused.We have a 5508 Wlc with many 1140 aps. And i would like to know how many clients can handle each access point.On this device there's a param under  wireless-802.11a/n 802.11b/g/n - gene...

i have two network seprated by firewall one side network is with WLC and 2 AP if i want to put 3rd AP in a zone which is behind the firewall what configuration is required and how AP will join WLC.Thanks

Hi,Can someone provide me detailed description on how WLC Radius Server Load balance works.Becuase, I encounted a problem of User Authenticated with the 1st Radius Server, but Accounting Records are actually on 2nd Server .Any response will be very a...

Hi there,I already have 1 WLC 5508 over production.I need to implement a secundary WLC and a wcs to the network.Whats is the best way to do it ?Im planning to install WCS, add the primary WLC to the wcs, and then the secundary.As its my first WCS ins...

Maybe someone can post an example configuration of an Cisco 1242 Autonomus (as Universal Workgroup Bridge)  associated to a non-Cisco AP (SSID: Test). One client with MAC AAAA.BBBB.CCCC.DDDD is behind the Cisco 1242. Encryption is WPA2-PSK AES or WPA...

Hi, I need to know step by step configuration while configuring WLC 2106 and 1130 AGI have found one link on cisco.com to configure WLC what exactly the configuration need to make on 1130 AG to bring them on the network. Any confguration or network s...