10-10-2018 11:06 AM - edited 07-05-2021 09:17 AM
Hi AP1130 is taken out of WLC. when console is connected to it, it requires password. the password is not default password. and i do not want to password recovery. What password it could be? In WLC, we only has password for users to access wifi. i do not think the password can be used for this. Anyone has some suggestion? Thank you
Solved! Go to Solution.
10-10-2018 12:39 PM
it should be whatever the AP credentials are entered in the controller.
on your controller, select wireless>global configuration and you'll see the AP login credentials.
you'll see the username, but I don't know of any way to see the password, but maybe if you see the username it will be one of your standard credential pairs.
10-11-2018 08:54 AM
Correct, All AP will use new username/password.
Regards
Dont forget to rate helpful posts
10-10-2018 12:39 PM
it should be whatever the AP credentials are entered in the controller.
on your controller, select wireless>global configuration and you'll see the AP login credentials.
you'll see the username, but I don't know of any way to see the password, but maybe if you see the username it will be one of your standard credential pairs.
10-10-2018 10:07 PM
As in other post mentioned..it is configured under global configuration page of WLC. If you forget it then only optoin to recover or change the password is to reset:
1. connect AP again to WLC for 5-10 min.
2. Reset the password on WLC (under global config page)
Regards
Dont forget to rate helpful posts
10-11-2018 07:26 AM
1. connect AP again to WLC for 5-10 min.
2. Reset the password on WLC (under global config page)
That means all APs under the wlc would use the new password, right?
10-11-2018 08:54 AM
Correct, All AP will use new username/password.
Regards
Dont forget to rate helpful posts
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide