what vlan will client take when central switched under flexconect

[Herman2018]

hi, can anyone please help advise what vlan will the client be put when the client connect to an SSID "test" and AP is in flexconnected mode. The ssid "test" is not in vlan mapping table of flexconnect, it is centrally switched.  Thanks in advance. 

on wireless controller, the interfaces are configured as below.

1. interface name "BH", vlan id 999 , ip address is 99.99.99.99/32

2. under wlan config - ssid "test" use the interface "BH",

3, management interface ip is 10.10.10.1 /24, under vlan 10

[Blue_Bird · Accepted solution]

Hello Herman2018,

Eventhough the ssid "test" is not in vlan mapping(manually), it mapped with default vlan which is vlan1.

Best regards
******* If This Helps, Please Rate *******

[Herman2018]

thanks @Blue_Bird for your advise!

[Rich R]

@Blue_Bird advice was wrong because the SSID is centrally switched!
The flex vlan mappings only apply to locally switched SSIDs.

[Haydn Andrews · Accepted solution]

For centrally switched SSIDs, on the 9800 you need to define the WLC interface for the VLAN you wish the clients to be dropped into

[Rich R · Accepted solution]

Flexconnect Mode, central switched SSID will behave the same way as Local Mode in most respects.  There are some minor differences in the way association is handled only.

So in your case the client will be in VLAN 999 on the WLC.

@Blue_Bird the SSID will not be in VLAN 1 of the AP because it is not locally switched!

[ammahend · Accepted solution]

it will be put into vlan 999, unless you are doing some dynamic vlan assigned through radius, in that case clients will be out into whatever dynamic vlan you assign it them as part of authorization policy.