01-05-2012 12:02 PM - edited 07-03-2021 09:19 PM
Hi All,
I have the 1152 connected to a Linksys router. My PC is connected to the same Linksys router.
My IP is 192.168.1.101.
The AP is 192.168.1.102.
I can ping it fine.
I put 192.168.1.102 in my browser and I get nothing. Says IE cannot display the webpage.
Any ideas?
Thanks again - Joe
Solved! Go to Solution.
01-05-2012 12:11 PM
make sure your console is set for 9600/none/8/1 flowcontrol needs to be off.
01-05-2012 12:05 PM
Can you telnet into the AP and post the config? It's possible the AP doesn't have the webserver enabled.
01-05-2012 12:09 PM
Negative on the telnet. It says "Could not open connection to the host".
I also have a console cable connected. I can see the info scroll by. But it's non-responsive to me hitting "enter".
Just cant seem to communicate with it. I reset it to factory default by holding down "Mode" button as it powered up.
Any ideas???
01-05-2012 12:11 PM
make sure your console is set for 9600/none/8/1 flowcontrol needs to be off.
01-05-2012 12:18 PM
Well, that's pretty embarrasing. I opened a new Hyperterminal session and made sure settings were as you stated. Now I can communicate. Thank you for that.
Next issue is username and password. Since I reset it to factory default (or so I think I did), I'm using "Cisco" for username and password. However it's saying "Authentication Failed".
Any ideas about that?
01-05-2012 12:20 PM
should be cisco/cisco for a default user/pass.
01-05-2012 12:27 PM
After further review, I dont think it has been reset to factory because the name it displays if from the former user.
how do you reset this thing? Everything I've read says hold down the "Mode" button at power up. Tried that a few times but doesnt seem to be working.
01-05-2012 12:32 PM
Holding the mode button should work. disconnect the power, press and hold the mode button. wait for 5-10 seconds, and release it.
If you stay connected to the console port, you'll see it boot up and should be ble to get into it.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide