05-13-2009 03:42 AM - edited 07-03-2021 05:35 PM
Dear all,
I have WiSM WLAN Service Module installed on 6509 core switch, everything was working fine, suddenly the first controller became unavailable and showing the following output
CoreSwitch# <strong>show wism mod 4 controller 1 status</strong>
WiSM Controller 1 in Slot 4
Operational Status of the Controller : Service Port Up
Service VLAN : 144
Service Port : 9
Service Port Mac Address : 0000.0000.0000
Service IP Address : 0.0.0.0
Management IP Address : 0.0.0.0
Software Version :
Port Channel Number : 289
Allowed vlan list : empty
Native VLAN ID : default
WCP Keep Alive Missed : 0
Second controller is working fine and showing the following:
CoreSwitch# show wism mod 4 controller 2 status
WiSM Controller 2 in Slot 4
Operational Status of the Controller : Oper-Up
Service VLAN : 144
Service Port : 10
Service Port Mac Address : 001a.6c22.8f62
Service IP Address : 192.168.100.3
Management IP Address : 10.41.1.21
Software Version : 4.2.176.0
Port Channel Number : 290
Allowed vlan list : empty
Native VLAN ID : default
WCP Keep Alive Missed : 0
<strong>Anybody can help??</strong>
05-13-2009 05:28 AM
Looks like you lost the service and management IP of the controller. Have you tried to console into the controller ?
05-13-2009 12:57 PM
Yes I tried console, and samething. One more thing is that the LED of the first controller is always orange!!
05-13-2009 02:09 PM
Orange? Sounds like you lost the firmware.
05-13-2009 09:06 PM
yup ... i had that on a install a few months back ... had to do a RMA....
I would call TAC and get this replaced. Dont waste your time on this one ...
05-13-2009 09:50 PM
Come to think of it ... Console into the WiSM A and check if you can load the secondary firmware. Otherwise, do what George recommend and RMA the blade.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide