New commands were added to 6500 IOS SXF6 to ease initial setup of the trunk and channel ports for the wism. Problem is after typing these commands I can't undo them. This is the "wism module <mod> controller 1 native-vlan" command.
After removing these commands and manually setting up the gig ports and channel/trunk the gig port are in a up/down state and the port channel is down/down. Seems like there is a disconnect between the automaticall created channel group with the new commands. It creates a channel numbered 288 or higher. You can then see this is somehow bound to the wism and it's ports.
Any ideas on how to fully remove the auto-assigned high port-channel interface? Or am I stuck doing it the auto way and I'll have to put the gig ports in the high channel-group?
sh wism module 4 controller 1 status
WiSM Controller 1 in Slot 4
Operational Status of the Controller : Oper-Up
Service VLAN : <snip>
Service Port : 9
Service Port Mac Address : <snip>
Service IP Address : <snip>
Management IP Address : <snip>
Software Version : 4.1.171.0
Port Channel Number : 289
Allowed vlan list : empty
Native VLAN ID : 1
WCP Keep Alive Missed : 0
