WISM2 7.5 deafult password

[CSCO11560536]

I have two new 6500, there WISM2 version 7.5 on each switch, connect the console interface requirements we input user and password, can anyone tell me the default user name and password? No search results on google，I've tried Cisco, admin, WISM, default as username and password, etc.but was unsuccessful！

[Stephen Rodriguez]

There shouldn't be a default username/password on the WLC when you are going through the initial setup.

you can try the recover-config from the console and see if that lets you go through with the setup.

HTH,

Steve

[Salma Sulthana · Accepted solution]

Hi,

Yes, as Steve mentioned there is no default username and password for initial configuration.

however, as you have already tried with the default username and passwords which most of the Cisco product have Like admin and admin or admin and Cisco.

 You can always recover or reset the password by following the steps below.

he procedure to reset the WiSM to its default settings is similar to the procedure to reset the WLCM.

Complete these steps in order to reset the WiSM to its default settings:

1. In privileged mode from the router prompt, enter this command:

   Router#hw-module module <module slot number> reset
   

   This command reboots the WiSM module. This is an example:

   Router#hw-module module 3 reset
   Proceed with reload of module?[confirm]

2. Access the console of the controllers using a serial connection.

3. When you are prompted for a username, enter recover-config in order to restore the factory default configuration.

   Here is an example:

   (Cisco Controller)
   
   Enter User Name (or 'Recover-Config' this one-time only to reset 
   configuration to factory defaults)
   

   User:recover-config

The controller reboots and displays this message:

 Welcome to the Cisco WLAN Solution Wizard Configuration Tool

Use the startup configuration wizard in order to enter new configuration settings including the username and password.

Regards

Salma

[CSCO11560536]

Thank you ! You are right!I've cleared my WISM2 password