cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1297
Views
0
Helpful
25
Replies

WLC 2112 after Soft- Update not accessible

Remo.Hehlert1
Level 1
Level 1

Dear all,

i have a problem after update my WLC from 5.2.193.0 to AIR-WLC2100-K9-7-0-252-0.aes

My steps:

download AIR-WLC2100-K9-7-0-252-0.aes

open WLC Gui

disabale all WLAN

go to command and download Image via FTP

press reboot

press save and reboot

after reboot the wlc hat the same config like before but new image 7.0.252.0.

But it is not accessible from the network. Link is up

I reset system 2 more times but nothing happen. sho run-config shows exectly the ols config

Only way was to boot from the old imange.

Any Ideer whats happend wrong?

thanks in advance

Remo

25 Replies 25

I did that allready George.

1. on 2960 SW native vlan 68, on wlc vlan 0 (untagged)

2. on wlc vlan 68 (tagged), on 2960 SW native vlan 68

3. on wlc vlan 68 (tagged), on 2960 SW without native vlan 68

nothing woud helpful with the new IOS Image

Can you ping the controller when both are tagging or I tagged forgot about http it https at the moment .. 

"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin
___________________________________________________________

No George in each case there is no ping possible

Something does see right. Post the entire show run of your controller and the switch as the config sits right now.

"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin
___________________________________________________________

SW and wlc Config

WLC is on old code. Can you update WLC to newer code and copy the WLC config here.

"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin
___________________________________________________________

of course it's on old code because on new one it's not working and I have no WLAN on our location!

The config is the same on new or old code!

Dear all,

i have now fixed the problem by usig a different IOS K9-7-0-220 Image.

But there is one more little problem. There is no ICMP insite / outsite possible.

That meens no Ping to WLC and from WLC to outsite.

But access to WLC via https - OK and all AP are joining the WLC.

Any Idear?

fixed now too by disable "CPU Access Control Lists"

thank you all for your help!

On the 2960X, post the output to the command "sh interface Gi1/0/13".

Javier Contreras
Cisco Employee
Cisco Employee

This is the wrong forum for this discussion, moving the thread

Review Cisco Networking for a $25 gift card