WLC 2504 and 1130AG

[ronald.lawrimore]

I have a 1130AG that has never been used. I cannot get it to see the WLC 2504 controller. It does pull a DHCP address. With the help of others here, I got the 3502I APs working.

Has anyone seen this issue before.                  

[George Stefanick]

Is the 1130 in autonmous mode or CAPWAP. What is the model number of the AP?

[George Stefanick]

Also did you put it on the managment vlan like with the 3500 ?

[ronald.lawrimore]

Yes, it is on the management VLAN, the model is AIR-AP1131AG-A-K9

[Scott Fella]

Is the 1131 lightweight or autonomous. If autonomous, you new to convert it to lightweight. If you can issue a config t it is autonomous. If it is lightweight, then post the output from the console.

Sent from Cisco Technical Support iPhone App

[ronald.lawrimore]

It must be autonomous, how cna I convert it to lightweight.

[Scott Fella · Accepted solution]

http://www.cisco.com/en/US/docs/wireless/access_point/conversion/lwapp/upgrade/guide/lwapnote.html

Sent from Cisco Technical Support iPhone App

[George Stefanick · Accepted solution]

Yea that autonomous.

http://www.cisco.com/en/US/docs/wireless/access_point/conversion/lwapp/upgrade/guide/lwapnote.html

[George Stefanick]

LOL.. My link is better than yours scott!

[ronald.lawrimore]

Can the process be reversed if needed.

[George Stefanick]

yup

[Scott Fella]

Haha.... Too funny

Sent from Cisco Technical Support iPhone App

[Scott Fella]

George is pretty fast today:)

Sent from Cisco Technical Support iPhone App

[ronald.lawrimore]

Thanks for all your help today Scott and George

[George Stefanick]

Here is a video that shows how to go back and forth from autonomous to capwap

http://www.youtube.com/watch?v=wWDrFjwVNb0