05-20-2019 02:11 PM - edited 07-05-2021 10:26 AM
I need to disable the network to make some changes to wireless networks. I get an error message that it is operational and cannot make chantes. I have some meshes enabled. Would the mesh come back if i connect to WLC and disable the network, make changes, then enable it?
05-20-2019 02:32 PM
Not sure what changes we are considering here.. explain more. with errors you see while changing.
05-20-2019 02:37 PM
Changes like Call Admission Control.
05-20-2019 04:34 PM
Hi,
Some changes require you to disable the radios before applying the change. You will need to take an outage windows, disable the radios, make the change and re-enable the radios. This should only impact the wireless network. You will still have access to the wireless controller over the wired network.
Thanks
John
05-20-2019 05:09 PM - edited 05-21-2019 03:25 PM
Thanks for the reply. I understand scheduling downtime and accessing the WLC from the wire. But how does the mesh come back online if WLC disables the network?
WLC > WAP1(RAP) > WAP2(MAP)
How does WAP2 receive the enable command after WLC tells them to turn off?
Does anyone have a mesh system to test?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide