Wireless

Hi,while i am trying to reconnect the Accesspoints getting below error message on APJoin in WLC2500series.... Lwapp discovery request rejected.Discovery request decoding with subnet broadcast and wrong AP IP address please help me out with steps need...

I'm trying to double NAT an Aironet 1815i access point. I have 3 of them and they are using the Mobility Express firmware, with one of the APs acting as the controller. I'm logged into the web portal, I create a DHCP pool on a different subnet from o...

HI everyone，This is the problem,could you help me to resoved it? 1、Product & Software：WLC PID：AIR-CT2504-K9AP PID：AIR-AP1852I-H-K9software：8.2.121.52、Symptom：The AP1852I can be registered to the WLC2504 normally and works normally. However, after a p...

Hello,I have two WLC model AIR-CT7510-K9 and am in the process of replacing the APs in the company.In WLC 1 are the current APs in the process of replacement and in WLC 2 are the new APs that we are replacing by the legacies.In WLC 2, I uploaded vers...

Hi all , first thanks for read my topic I am just newbie for Cisco wireless. Let 's start. Now I I have AP1832i(Master AP) Mobility firmware version 8.3  I want upgrade it to 8.5 so I can't upload to controller system.  My Controller IP  192.168.0.10...

Please could someone suggest me for the following. I have already working Cisco 2600 AP with Windows 2012 Radius Server not I would like to extend wireless signal by putting new Cisco 2600 AP as repeater. I have configured  new 2600 AP role as repeat...

Hello Team,  users are disconnecting between when they are using barcode scanners . first I did changes band 5ghz but feedback was very bad. Then I set 2.4g still they are facing issue . What to do now.

Hi all, I have a Cisco WLC 2504 running 8.5.120.0 software version connected to two APs AIR-AP1852I-S-K9. I have a problem with wifi connectivity that an user is disconnected from WLAN when walking from AP1 to AP2 coverage. And the log shows that ...

Hello,   I have an access point, air-ap4800-e-k9 model. But I could not configure it. Firstly, I connect it power machine , it power AP with poe. I access ap with console  cable.  Then I connect it with controller. But it does not broadcast. I am new...

Hi Everyone, I need a little bit of verification based on facts; I am aware that Cisco APs designated for my region (Nigeria) are the AIR-CAP3702I-E-K9 model APs. I want to find out if the model AIR-CAP3702I-A-K9 can be used here also. Cisco does not...

When I go to the below path I do not see any devices (which I have +900 WLCs managed), associated to any profiles.   Step 1 Choose Inventory > Device Management > Credential Profiles . Step 2 Choose a credential profile, then click Edit .   Looking f...

I have current wireless infrastructure with cisco 3600 and 2700 APs and would like to set one 1602 AP to be mesh or repeater so it can be mobile. currently it's getting an error message of non WPAv2 PSK.   Do I need to set one AP to be a Root AP and ...

Currently working with Cisco 1552s Access Points in a production environment. These APs are being used to monitor sensors in the production environment for safety monitoring. I have been searching for information on how many sensors one of these APs ...