01-29-2012 10:07 PM - edited 07-03-2021 09:28 PM
Can we do the same thing with WCL 4400 and 5500 series for failover? We have 1 existing 4400 WLC and we wanted to purchase another 1 for fail-over as well as backup. But right now, 4400 is EOL already. The only option is to have the 5500 WLC.
So if you do have previous set-up like this, so I would need your inputs.. Otherwise, same as usual, will gonna test to work this out.
01-29-2012 11:00 PM
You can have both in a primary and backup, but make sure they are on the same code version. I'm assuming that you also have the configuration correct for the two wlc to communicate.
I would put them both on the 7.0.220.0.
Sent from Cisco Technical Support iPhone App
01-29-2012 11:47 PM
Hi Scott, thank you very much for your prompt response. I will keep you posted if I do encounter some issues.
01-30-2012 04:54 AM
Sounds good.
03-03-2012 09:45 PM
Hi Scott,
Just would like to ask some verification from your end. Is NCS a replacement for WCS? or it's just another piece of software that is built from WCS platform?
03-03-2012 09:56 PM
Just would like to ask some verification from your end. Is NCS a replacement for WCS?
NCS replaces the WCS.
NCS comes in two "flavours": VMware and appliance
03-03-2012 10:00 PM
Hi Leo,
Ah.ic..Thanks much for your prompt response...Keep it up.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide