Wireless

Hi,My laptop running Spectrum Expert passed away and I can't find another laptop with a cardbus slot in my company. Does anyone knows of any USB or ExpressCard to Cardbus adapter out there? Been searching and I've found some CardBus to USB adaptors b...

Is it possible to see device information for equipmnet that is logged into the AP541N access point?  I was able to determine a specific IP address was eating a significant amount of bandwidth and was hoping to get the device information (name, type, ...

Hi,On autonomous AP's one can disable the bright status LED using the "led ....." command. But how can I disable the LED on a LAP-1131AG? The AP hangs in a bedroom so the light is quite annoying.Thanks!

I've been asked to generate some report data on a specific WLAN, a limited access WLAN that was added recently. We need to be able to report on "Average and Peak Number of clients (Total)" and "Total Bytes Transferred (all  APs)" on a per site basis....

My installation has 4 wired AP´s with 8dbi antennas. They are in a equidistante square position in a campus. Because I have only 3 non-overlaped channels, what is the best separation (in metres) between them?Actually they are 70m far away.Regards.

My question is, how i can limit the bandwidth for a all my client conect to the AP, i have a Aironet 1200 with the 12.2.15 code.Thanks in advance.

Can someone guide me to a website on BEst Practices for deplying Access Points?Thanks In Advance

For the past week, I've been looking to implement wireless technology at our educational site. We've conducted some tests with an AP1200 and we were satisfied with the performaces of 802.11a standards. Since one of our requirements is bandwith, we ar...

Hi,does Cisco make a 802.11g AP and if so what series is it?thanks,James

Hi all,We are using NCS 1.2 to monitor and manage our WLCs. We are also using  different Virtual Domains per region.On our network we are using Campus WLCs that anchor their traffic to Anchor WLCs behind a DMZ.When we add a Campus WLC  to NCS and try...

Good mooring,My lab is:1)  Virtual controller 7.3.112  is OK2)  N° 2 LAP 1130 e 1240   is Joined to controller OK3)  flexconnect in localswitch is OK4)  flexconnect in central switch IS NOT work.please can you help me to find the problem.

Hi Guys,At the moment we are in the process of deploying city wide free public wireless. I'm trying to think ahead of the design of the network. We want to deploy the same SSID but I'm not sure if we should use one vlan for the end users which would ...

Hello,i have this cisco aironet 1300 series.. i would like to console it.. but i cannot get to the console..i think i have a problem with its baud rate,it will not accept the 9600.. anyone who has tried this?thanks