08-27-2012 12:06 AM - edited 07-03-2021 10:34 PM
hi ALL,
We have 4 x 4xxx WLCs setup in our Core.
I just created an AP group in one of WLC and in theory I should see that AP group in the other 3 x WLCs
For some reason, I do not see that AP group appear in other 3 x WLCs.
Very much appreciated if someone could point me to the right information or troubleshoooting steps.
Thanks
Ql
Solved! Go to Solution.
08-27-2012 05:01 AM
QI:
I agree with Scott. confiugration on one WLC is not propagated to other WLCs. (What piece of config or doc that makes you think like that?).
If you have WCS (or NCS) you can create a template and push it to all WLCs you have. But if you dont then you need to manually configure all WLCs.
HTH
Amjad
You want to say "Thank you"?
Don't. Just rate the useful answers,
that is more useful than "Thank you".
08-27-2012 04:23 AM
You are wrong here. You need to configure every wlc seperate. There is no syncing between WLC's.
Sent from Cisco Technical Support iPhone App
08-27-2012 05:01 AM
QI:
I agree with Scott. confiugration on one WLC is not propagated to other WLCs. (What piece of config or doc that makes you think like that?).
If you have WCS (or NCS) you can create a template and push it to all WLCs you have. But if you dont then you need to manually configure all WLCs.
HTH
Amjad
You want to say "Thank you"?
Don't. Just rate the useful answers,
that is more useful than "Thank you".
08-27-2012 06:50 AM
Hi,
As mention above the WLCs do not sync the configuration between WLCs, you need to do it on each WLC, unless you have a WCS or NPS server managing your WLCs and you can apply templates from the WCS or NPS server to the WLCs.
08-27-2012 08:00 PM
Thank you all.
We do not have WCS or NPS so I guess I have to configure each WLC manually.
QL.
08-29-2012 01:31 PM
Hi,
Glad to help by NPS i meant NCS server, type error
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide