I have configured a 6509 with a port-channel over 2 interfaces as the ap-manager interface for a 5508 WLC, see below. I am not able to ping the WLC ap-manager interface from the 6509 console port. The WLC ap-manager interface is on the vlan101 subnet and uses vlan tags.
interface Port-channel9
description ether channel for WLC 1
switchport
switchport trunk encapsulation dot1q
switchport trunk native vlan 101
switchport trunk allowed vlan 101,113,127
switchport mode trunk
logging event link-status
logging event bundle-status
!
interface GigabitEthernet7/2
description ether channel for WLC 1
switchport
switchport trunk encapsulation dot1q
switchport trunk native vlan 101
switchport trunk allowed vlan 101,113,127
switchport mode trunk
logging event link-status
logging event bundle-status
channel-group 9 mode on
!
interface GigabitEthernet8/2
description ether channel for WLC 1
switchport
switchport trunk encapsulation dot1q
switchport trunk native vlan 101
switchport trunk allowed vlan 101,113,127
switchport mode trunk
logging event link-status
logging event bundle-status
channel-group 9 mode on
!
port-channel load-balance src-dst-ip
and the 5508 is using:
Version: 6.0.199.4
I found in the manual (Cisco Wireless LAN Controller Configuration Guide, Software Release 7.0 June 2010,) to try using :
port-channel load-balance src-dst-ip exclude vlan
but the 6509 won't take it. Any ideas?
