WLC 9800 Anchor

[suthakar sundaralingam]

Hi All,

I'm trying to setup Cisco 9800-CL (in VMWare) as primary (Foreign controller) and Anchor (In DMZ). I have completed the primary controller configuration and got the WAPs joined and working as expected for Flex-connect (locally switches vlans), but I have few questions around anchor WLC configuration, particularly around centrally switched vlan configurations/clients

1. Since the Access-points are only joined to the primary controller, how do I attached/influence the (WLAN profile+Policy profile) features to the guest clients who gets tunneled into the guest WLC?

2. Is there any document available at Cisco website with detailed explanations?

Please advise.

Regards,

Suren

[Scott Fella]

Suren,

Take a look at the following guides:
https://www.cisco.com/c/en/us/support/docs/wireless/catalyst-9800-series-wireless-controllers/213912-configure-mobility-anchor-on-catalyst-98.html <>
https://www.cisco.com/c/en/us/support/docs/wireless/catalyst-9800-series-wireless-controllers/213913-building-mobility-tunnels-on-catalyst-98.html#anc4 <>

The top link is what you should follow.