WLC 9800 Syslog

[OJ_Magellan]

Hi 

I want to configure WLC 9800 to send Syslog messages to an external Syslog server. In the configuration I can only see the configurations for the IP address and  vrf, how about the protocol and port number? what does the WLC uses? UDP 514?

Regards,

OJ

[Arshad Safrulla · Accepted solution]

Yes default is udp 514, You can set this on CLI

loggin host <IP Address> transport <TCP/UDP> port <PortNumber>

[OJ_Magellan]

so only through the CLI the Port and Protocol are adjustable? cause through the GUI its not possible.

[Sandeep Choudhary · Accepted solution]

No, at the moment via GUI is not possible. May be in future cisco may update these setting in GUI as well.

Regards

Dont forget to rate helpful posts 

[OJ_Magellan]

Since the WLC is connected to the DNAC, is it possible to configure l"oggin host <IP Address> transport tls port <PortNumber>" through the DNAC or the only possible way is the WLC's CLI?

Regards,

OJ