Solved: Re: WLC2504 Dynamic Vlan

hs08 · ‎08-27-2026

I successfull create dynamic vlan on WLC 9800, but it's not work for WLC 2504. Should i create dynamic interface group on WLC 2504 for dynamic vlan?

aleabrahao · ‎08-27-2026

Is the SSID configured with local switch or central switch?

If it's local switch (flex connect), you should have to map the vlan on the flex connect group.

https://www.esharp.net/configuring-cisco-flexconnect-ap-to-support-dynamic-vlan-assignment-with-ise/

I am not a Cisco employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

View solution in original post

aleabrahao · ‎08-27-2026

Is the SSID configured with local switch or central switch?

If it's local switch (flex connect), you should have to map the vlan on the flex connect group.

https://www.esharp.net/configuring-cisco-flexconnect-ap-to-support-dynamic-vlan-assignment-with-ise/

I am not a Cisco employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

hs08 · ‎08-28-2026

Hi @aleabrahao

yes i use local switch and after read article what you share then the dynamic vlan is working. Previously i already create flexconnect group but i set on WLAN VLAN mapping and here i only can map 1 ssid with 1 VLAN.

aleabrahao · ‎08-28-2026

yup, you need to MAP under AAA VLAN MAP.

I am not a Cisco employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

ammahend · ‎08-27-2026

Please elaborate on your question.

https://community.cisco.com/t5/security-knowledge-base/how-to-ask-the-community-for-help/ta-p/3704356

-hope this helps-