WLCCA

[CChris91]

Just came across this tool but having a few issues. I'm a newbie to all this but I've followed the instructions but I'm receiving a "Controller information not found in selected file. Please load the output of shrun-config, with paging disable for best results". 

All I've done at this point is uploaded the running config via the Cisco 5508 WLC GUI, to a TFTP server in a .txt file.

I then try to open the config file through WLCCA and get this error. I'm probably doing something incredibly stupid or missing an obvious step. Can anyone help?! 

Thanks!

[Divya]

Hi Chris,

Do a SSH/Telnet session using WLC mgmt IP address & log the session.

run the commands:

config paging disable

show run-config

config paging enable

Refer this link: https://supportforums.cisco.com/t5/wireless-mobility-documents/wlc-config-analyzer-how-to-load-a-file/ta-p/3115077

Regards,

Divya