WLSE : not accept firmware 12.3(4)JA

[sdugravot]

When i am trying to apply new firmware -12.3(4)JA- to an AP1210, WLSE alert me when saving job :

:

Job protocol validation ... Passed

Image version validation ... Warning

Details ...

Imagec1200-k9w7-tar.123-4.JA.tar (12.3(4)JA ) Not recognized.

Device-Image validation ... Warning

Details ...

Device ap1200-cran01.uhp-nancy.fr (AP1210, 12.3(2)JA) Device may/may not accept the selected image. Image has higher version but is not recognized.

So, i have upgrade WLSE from 2.9 to 2.9.1a ... but nothing change.

When i read the help pages, i find that i have to download something from :

http://www.cisco.com/kobayashi/sw-center/cw2000/crypto/wlan-sol-eng

But i find nothing which seem's to be the right thing (except upgrade wlse to 2.9.1a, that's why i have upgrade)... What we have to download exactly ?

S.

[rmushtaq]

2.9.1a do not support this IOS version. Next release will. But you can ignore this warning message and the job should go through ok.

[rmushtaq]

Upgrade to WLSE 2.11 on CCO and it will take care of it.

[sdugravot]

Thx !

But, in the readme file, i have found :

-> You can upgrade to Release 2.11 if you have a WLSE 1130 or

WLSE 1130-19 already running Release 2.7, 2.7.1, 2.9 or 2.9.1a.

Release 2.11 is not supported on the WLSE 1105.

How can i determine if my version is WLSE 1130 or WLSE 1105. I don't understand ... My version is WLSE 2.9.1a. And if WLSE is a 1105 version, what can i do ?

[EDIT] Sorry, i have found that my WLSE is a 1130 :-) so i can upgrade to 2.11

[/EDIT]

S.

[rmushtaq]

show version or About in WLSE GUI will tell you the model type