WLSE .... SNMP & CDP??

[alahmadi]

I have WLSE Release 2.5

And Cisco APs "350, 1200" IOS & VxWorks (Non-IOS)

I configured the SNMP & CDP in all APs,

Community strings are setup correctly and matches exactly with that entered in WLSE

Only I discovered all IOS APs but it didn't discover all "Non-IOS" AP!!

Please advice

Regards

[rmushtaq]

Connect to the Web GUI of the VxWorks AP and goto Setup->Security->User Information and make sure that you have a user there with all rights enabled for Write, SNMP, Ident, Firmware and Admin. Then login to WLSE and goto Devices-Discover->Device Credentials->SNMP Communities and make sure that the same user exists in this screen. If not, then enter it and try doing the discovery again.

[alahmadi]

thankx alot. it works 🙂

now all AP have been discovered by WLSE

many thankx