40X10GE-WLO not shown/powered on CRS-8/S-B-400G

[Aaziz AMHAOUCH]

Hi All,

I have a problem in CRS 8/S 400G: I have a 40X10GE-WLO Line Card on Slot 0 but it is not powered on and not shown in "show inventory" CLI command output. I tried to put this card in other slot but I had the same problem

You will find in attached all information about ths CRS : show version, show platform,...

Thank you for your help !

BR,

Aaziz

[eduardopozo56 · Accepted solution]

Are you installing the MSC on the back slot  from where you are installing the 40X10GE-WLO?

[Aaziz AMHAOUCH]

Hi Eduardo,

Thanks for your reply, the MSC was installed in another slot :) 

Thank you !

BR