ASR9001 upgrade to 5.1.0

[danabersoch]

Hi Guys,

I have upgraded a2 X ASR 9001 routers from 4.3.1 to 5.1.0, everything seems to be ok but they are not in production so haven 't had a propoer test.

My concern is that I am getting the below erro whenever I boot them:

RP/0/RSP0/CPU0:Sep 24 14:49:15.733 : ssm_process[419]: %OS-SSM-6-NODAL_SERVICE_STATE_CHANGE : Nodal service state changes from AVAILABLE to UNAVAILABLE

&

LC/0/0/CPU0:Sep 24 14:52:30.564 : ssm_process[351]: %OS-SSM-6-NODAL_SERVICE_STATE_CHANGE : Nodal service state changes from AVAILABLE to UNAVAILABLE

Can anyone hlep me with this? what is the 'Nodal' service, should I be concerned?

Thanks a lot in advance.

[Andre Gustavo Albuquerque]

Did you follow the procedures described at

http://www.cisco.com/web/Cisco_IOS_XR_Software/pdf/ASR9000_Upgrade_Procedure_510.pdf ?

Cheers, Gustavo

[danabersoch]

I did, I read it a couple of times

[Andre Gustavo Albuquerque]

Hi,

For this issue, IMHO, it's better to open a TAC case to investigate the issue.

Cheers, Gustavo

[narvenka]

Hi.

Do you see any side effects because of this message ? If show ssm detail does not alarm you any specifics, then its just harmless message. Make sure your services are AVAIL with show ssm detail command.

Thanks

Venkat Nagarajan