ASR9010 replacing PEM v1 to v3

[spitfire]

Hello everyone.

Our customer plan to upgrade power supply on ASR9010 from

1) v1 DC (A9K-2KW-DC, VID: V01) to v3 DC (A9K-DC-PEM-V3 + PWR-4.4KW-DC-V3)

2) v1 DC (A9K-2KW-DC, VID: V01) to v3 AC (A9K-AC-PEM-V3 + PWR-6KW-AC-V3)

I can’t clearly understand replacing procedure.

https://www.cisco.com/c/en/us/td/docs/iosxr/asr9000/hardware-install/hig/b-asr9k-hardware-installation-guide/b-asr9k-hardware-installation-guide_chapter_0101.html#task_1323197

For 1) in cli

#run

# pwrmod_change

In step 3 I don’t see “DC power supply version 3, fits …”For 2) In step 3 I don’t see “AC power supply version 3, fits …”How correctly replace power supply?

[nkarpysh · Accepted solution]

Good Day,

Thanks for checking. It seems the output in the doc is truncated. You will see following on the router itself:
1)      AC power supply version 1, fits 3 across in single power shelf
2)      DC power supply version 1, fits 3 across in single power shelf
3)      AC power supply version 2, fits 4 across in single power shelf
4)      DC power supply version 2, fits 4 across in single power shelf
5)      AC power supply version 3, fits 3 across in single power shelf
6)      DC power supply version 3, fits 4 across in single power shelf

I created DDTS CSCvj56819 to fix the doc.

Niko