XR OS and Platforms

Hi Guys I have tried all versions of IOS-XRv for Virtual Box and VMware, but in both cases the IOX-XRv crashes as soon as it boots.with the following error:Section:idt offset:0x0000006c  base:fed155b4Section:pgdir offset:0x00000070  Page Directory 00...

How many HSRP / Subinterfaces will be recomend to be the max in a Teng. port for an ASR-9001. If i have over 500, what will be the configuration best practice? I have seen Multiple Group Optimization (MGO) for HSRP as an option, but i dont have a cle...

Hi, Community: I've been trying to find the best solution for the following problem. As I understand it, for me to send IP traffic to an ISM or VSM on an ASR9k for CGN(ex: NAT44), the solution would be to use ABF and configure the ISM/VSM as next-hop...

Hi! I Have a CRS-8 with 10 downlinks. All the 10 downlinks are operational. I have configured 10 static routes to the same IP destination pointing to these 10 links for redundancy and balancing. The static routes are pointing to the IP next-hop and t...

Hi, I have XRv virtual router installed with IOS-XR version 5.2.0 in demo mode.I have BGP flowspec configured on it and I have BGP neighbors advertising flowspec NLRI to it.I have a problem where a long flowspec rule advertised to XRv is re-advertise...

We have a few thousand broadband customers in our network with various speed packages.  The highest speed package of 500Mbps. I'm trying to create an ingress QoS policy that I can apply on my interface facing my upstream providers that will limit put...

Hi all !I have an ASR 9001 router on which I have for the moment not configured QoS at all.Here is the diagram of my lab network :[HOST_A] ---- [ASR9001] ---- [ROUTER2] ---- [HOST_B]I have configured a BGP peering session between ASR9001 and ROUTER2....

The packet rate mib 1.3.6.1.4.1.9.2.2.1.1.7 for 7600 seem not support by ASR9K, anyone can share the packet rate /s mib for ASR9K

I'm trying to implement Policy Based Tunnel Selection on ASR 9k. Official documentation is completely wrong about it, stating we should use "policy-class" command. Instead, I was told by TAC a while ago that we should be using "forward-class", which ...

Hi, I have the following configuration on IOS XRv (5.3.0): control-plane management-plane  out-of-band   vrf MGMT   interface MgmtEth0/0/CPU0/0    allow SSH    allow Telnet   !  ! !!interface MgmtEth0/0/CPU0/0 cdp vrf MGMT ipv4 address 10.6.6.202 255...

 We have recently purchased ASR 9010 with one RSP and 2x 4 10GIG port card. The device has come with commando socket to be installed in one of the datacentre. I would like to test the device in office before shipping. has anyone had this experience? ...

Hello. Couldn't get right RPF neighbor in pim topology: RP/0/RSP0/CPU0:bgw0#sh pim multicast topology all rpf Mon Mar 16 12:04:59.319 UTC Table: IPv4-Multicast-default * *.*.1.215/32 [20/0] via Null with rpf neighbor 0.0.0.0 * *.*.1.216/32 [2...