Difference between A9K-4T-L, A9K-4T-B, A9K-4T-E

[mtenorio]

Im trying to find out the differences between the following line cards: 

A9K-4T-L

A9K-4T-B

A9K-4T-E

I see that appearently Queuing is the difference, but i would like to confirm if there is any other difference

[Ivan Krimmel]

Hi Mario,

in general, Extended, Base and Low memory options allow the same scale numbers, including FIB, MAC address, Bridge-domain, L3 sub-interface, VRF, etc. The difference is that E/B/L line cards have different TCAM, Stats and Frame Memory size, which give different scale number of the QoS queues and L2 sub-interfaces per line card.

Hope that clarified,

Cheers,

Ivan.

[Alexei Kiritchenko]

Hello Mario,

Here is the difference

LineCard              EFPs     Egress Queues     Policers     Buffering

=============================================================================

Low Queue     -L     4k        8/port             8k               50ms

MediumQueue   -B    16k        64k                128k             50ms

High Queue    -E    32k        256k               256k             150ms

[mtenorio]

Thank you Guys.

This was of much help