10-16-2013 01:15 PM
When I check 'show inventory' output in ASR9k, I can't see any PID displayed for SFP. I am aware that it is an electrical SFP but I want to know this from any output from the CLI.
Command Output is attached for the reference.
If I have no physical presence at the router site then how do I to get to know that installed SFP is electrical SFP or optical SFP
10-16-2013 11:51 PM
Use the command sh controllers gigabitEthernet 0/x/y/z phy
For example:
RP/0/RSP1/CPU0:ASR9K#sh controllers gigabitEthernet 0/2/0/10 phy
SFP EEPROM port: 10
Xcvr Type: SFP
Xcvr Code: 1000BASE-T
Encoding: 8B10B
Bit Rate: 1300 Mbps
Link Reach Copper: 100 meter
04-18-2018 01:03 AM
Here some useful link:
http://www.cisco.com/c/en/us/td/docs/interfaces_modules/transceiver_modules/compatibility/matrix/GE_Tx_Matrix.html
http://www.cisco.com/c/en/us/products/collateral/interfaces-modules/gigabit-ethernet-gbic-sfp-modules/product_data_sheet0900aecd8033f885.html
http://www.cisco.com/c/en/us/support/docs/interfaces-modules/cwdm-gbic-sfp/72370-sfp-trcvr-mods.html#model2
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide