Hi all,
I have an ASR9K with BNG and a CPE that connects to PPPoE on my ASR9K.
I try RIPv2 between my CPE and my PE but impossible to send and receive my routes.
With debug, I have this:
rip [1058]: ignored packet from 172.27.50.10 (could not find interface)
The problem is that in the RIP router configuration, I can not set PPPoE interface.
It works perfectly on an IOS-XE, but I could define a "network subnet".
I missed something, here is an example of my configuration :
My ASR9K:
!
interface GigabitEthernet0/0/0/19.1799
service-policy type control subscriber PPP_PM
pppoe enable bba-group DEDE
encapsulation dot1q 1799
!
dynamic-template
type ppp PPP
ppp authentication chap pap
accounting aaa list default type session
ipv4 verify unicast source reachable-via rx
!
!
pppoe bba-group DEDE
service selection disable
!
class-map type control subscriber match-any PPP
match protocol ppp
end-class-map
!
!
policy-map type control subscriber PPP_PM
event session-start match-first
class type control subscriber PPP do-until-failure
1 activate dynamic-template PPP
!
!
event session-activate match-first
class type control subscriber PPP do-until-failure
10 authenticate aaa list default
!
!
end-policy-map
!
router rip
vrf TEST
!
interface gigabitEthernet 0/0/0/19.1799
!
neighbor 172.27.50.10
route-policy pass-all in
!
!
My PPPoE Interface :
RP/0/RSP0/CPU0:ASR9K-TEST#sh subscriber session all
Mon Nov 19 09:56:21.301 CET
Codes: IN - Initialize, CN - Connecting, CD - Connected, AC - Activated,
ID - Idle, DN - Disconnecting, ED - End
Type Interface State Subscriber IP Addr / Prefix
LNS Address (Vrf)
--------------------------------------------------------------------------------
PPPoE:PTA Gi0/0/0/19.1799.pppoe191 AC 172.27.50.10 (TEST)
BR
Nick
