I have an L2VPN issue with XRv, would appriciate if some one can point me to what am I missing here:
XRv1 Configuration:
!
interface GigabitEthernet0/0/0/0.508 l2transport
dot1q vlan 507
!
!
l2vpn
xconnect group xc1
p2p ac2ac1
interface GigabitEthernet0/0/0/0.508
neighbor ipv4 20.255.24.24 pw-id 507
!
interworking ethernet
!
XRv2 Configuration:
!
interface GigabitEthernet0/0/0/0.508 l2transport
dot1q vlan 508
!
!
l2vpn
xconnect group xc1
p2p ac2ac1
interface GigabitEthernet0/0/0/0.508
neighbor ipv4 20.255.23.23 pw-id 507
!
interworking ethernet
!
!
RP/0/0/CPU0:XRv1#show l2vpn xconnect
Tue Mar 25 16:33:44.567 UTC
Legend: ST = State, UP = Up, DN = Down, AD = Admin Down, UR = Unresolved,
SB = Standby, SR = Standby Ready, (PP) = Partially Programmed
XConnect Segment 1 Segment 2
Group Name ST Description ST Description ST
------------------------ ----------------------------- -----------------------------
xc1 ac2ac1 UP Gi0/0/0/0.508 UP 20.255.24.24 507 UP
----------------------------------------------------------------------------------------
RP/0/0/CPU0:XRv1#
RP/0/0/CPU0:XRv1#show l2vpn xconnect detail
Tue Mar 25 16:34:06.846 UTC
Group xc1, XC ac2ac1, state is up; Interworking Ethernet
AC: GigabitEthernet0/0/0/0.508, state is up
Type VLAN; Num Ranges: 1
VLAN ranges: [507, 507]
MTU 1500; XC ID 0x1; interworking Ethernet
Statistics:
packets: received 0, sent 0
bytes: received 0, sent 0
drops: illegal VLAN 0, illegal length 0
PW: neighbor 20.255.24.24, PW ID 507, state is up ( established )
PW class not set, XC ID 0xff000001
Encapsulation MPLS, protocol LDP
Source address 20.255.23.23
PW type Ethernet, control word disabled, interworking Ethernet
PW backup disable delay 0 sec
Sequencing not set
PW Status TLV in use
MPLS Local Remote
------------ ------------------------------ -----------------------------
Label 16135 16044
Group ID 0x200 0x200
Interface GigabitEthernet0/0/0/0.508 GigabitEthernet0/0/0/0.508
MTU 1500 1500
Control word disabled disabled
PW type Ethernet Ethernet
VCCV CV type 0x2 0x2
(LSP ping verification) (LSP ping verification)
VCCV CC type 0x6 0x6
(router alert label) (router alert label)
(TTL expiry) (TTL expiry)
------------ ------------------------------ -----------------------------
Incoming Status (PW Status TLV):
Status code: 0x0 (Up) in Notification message
Outgoing Status (PW Status TLV):
Status code: 0x0 (Up) in Notification message
MIB cpwVcIndex: 4278190081
Create time: 25/03/2014 11:12:17 (05:21:49 ago)
Last time status changed: 25/03/2014 16:06:57 (00:27:09 ago)
Last time PW went down: 25/03/2014 16:02:55 (00:31:11 ago)
Statistics:
packets: received 0, sent 0
bytes: received 0, sent 0
RP/0/0/CPU0:XRv1#
RP/0/0/CPU0:XRv1#show l2vpn forwarding detail location 0/0/CPU0
Tue Mar 25 16:34:39.823 UTC
Local interface: GigabitEthernet0/0/0/0.508, Xconnect id: 0x1, Status: down
Segment 1
AC, GigabitEthernet0/0/0/0.508, Ethernet VLAN mode, status: Not bound
Statistics:
packets: received 0, sent 0
bytes: received 0, sent 0
Segment 2
MPLS, Destination address: 20.255.24.24, pw-id: 507, status: Not bound
Pseudowire label: 16044 Control word disabled
Statistics:
packets: received 0, sent 0
bytes: received 0, sent 0
RP/0/0/CPU0:XRv1#ping mpls pseudowire 20.255.24.24 507
Tue Mar 25 16:35:31.850 UTC
Sending 5, 100-byte MPLS Echos to 20.255.24.24 VC: 507,
timeout is 2 seconds, send interval is 0 msec:
Codes: '!' - success, 'Q' - request not sent, '.' - timeout,
'L' - labeled output interface, 'B' - unlabeled output interface,
'D' - DS Map mismatch, 'F' - no FEC mapping, 'f' - FEC mismatch,
'M' - malformed request, 'm' - unsupported tlvs, 'N' - no rx label,
'P' - no rx intf label prot, 'p' - premature termination of LSP,
'R' - transit router, 'I' - unknown upstream index,
'X' - unknown return code, 'x' - return code 0
Type escape sequence to abort.
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/2/10 ms
RP/0/0/CPU0:XRv1#
