Hi guys,
A want to know how can configure a NAT statics on the ASR9000, the ASR have de IOS-XR 4.3.4 and the configuration is the next:
hw-module service cgn location 0/4/CPU0
!
interface ServiceInfra 1
ipv4 address 100.10.200.253 255.255.255.252
service-location 0/4/CPU0
!
interface Gigabitethernet 0/0/0/19
description INSIDE
vrf ivrf1
ipv4 address 192.168.0.254 255.255.255.0
!
interface ServiceApp1
desciption INBOUND INSIDE TO ISM
vrf ivrf1
ipv4 address 100.10.200.1 255.255.255.252
service cgn prueba service-type nat44
!
interface ServiceApp2
description OUTBOUND OUTSIDE
ipv4 address 100.10.200.5 255.255.255.252
service cgn prueba service-type nat44
!
router static
address-family ipv4 unicast
191.20.20.0/24 ServiceApp2
!
vrf ivrf1
address-family ipv4 unicast
0.0.0.0/0 ServiceApp1
!
service cgn prueba
service-location preferred-active 0/4/CPU0
service-type nat44 nat1
portlimit 65535
alg ActiveFTP
alg rtsp
alg pptpAlg
inside-vrf ivrf1
map address-pool 191.20.20.0/24
!
!
!
protocol udp
session initial timeout 30
session active timeout 120
!
protocol tcp
session initial timeout 120
session active timeout 1800
!
protocol icmp
timeout 60
!
refresh-direction Outbound
The configuration above is working perfect and i can reach internet, now a need to migrate the next configuration of nat static to the ASR9000
ip nat inside source static tcp 192.168.0.205 3299 191.20.20.205 3299 extendable
Can help please..
Would greatly appreciate if you could help me
Thanks.
Fredy Caceres
