Hi
I know that you implemented some shortcuts in 5.1.3 for bundle-ether and TenGigabitEthernet. Any plans to implement the same function for pw-ether? Really annoying to work with pw-ether at the moment, when it gets displayed as PExxxxx in some views but you must use pw-ether xxxxx to show/configure the interface
RP/0/RSP0/CPU0:9k#show interfaces description | in PE
Wed Nov 19 13:47:47.177 CET
PE10001 up up test-xxxxx
RP/0/RSP0/CPU0:9k#show interfaces PE10001
^
% Invalid input detected at '^' marker.
RP/0/RSP0/CPU0:9k#show interfaces pw-ether10001
Wed Nov 19 13:49:35.505 CET
PW-Ether10001 is up, line protocol is up
Interface state transitions: 11
Hardware is PWHE Ethernet Interface, address is a80c.0d71.4215
Description: test-xxxxx
Internet address is 1.1.1.1/31
MTU 1514 bytes, BW 10000 Kbit (Max: 10000 Kbit)
reliability 255/255, txload 0/255, rxload 0/255
Encapsulation ARPA, loopback not set,
ARP type ARPA, ARP timeout 04:00:00
L2Overhead: 0
Generic-Interface-List: pw-he
Last input 00:00:00, output 00:00:00
Last clearing of "show interface" counters never
30 second input rate 1000 bits/sec, 4 packets/sec
30 second output rate 1000 bits/sec, 4 packets/sec
3830527 packets input, 989740649 bytes, 4521 total input drops
0 drops for unrecognized upper-level protocol
Received 0 broadcast packets, 4501 multicast packets
3861314 packets output, 921387947 bytes, 0 total output drops
Output 0 broadcast packets, 78706 multicast packets
RP/0/RSP0/CPU0:9k(config)#interface pe10001
^
% Invalid input detected at '^' marker.
RP/0/RSP0/CPU0:9k(config)#interface pw-ether 10001
RP/0/RSP0/CPU0:9k(config-if)#
/Regards Peter
